Manual-Calibration Fibreoptic SensorFS-V/T/M series (FS01)

FS-M2P

Fibre Amplifier, Cable Type, Expansion Unit, PNP

SPECIFICATIONS

Select Language

Model

FS-M2P

Type

1-line expansion unit

Output

PNP

Light source

Red LED

Sensitivity adjustment/Mode selection

8-turn trimmer (with indicator), FINE/TURBO (switch-selectable)

Response time

250 μs (FINE)/500 μs (TURBO)

Operation mode

LIGHT-ON/DARK-ON (switch-selectable)

Indicator lamp

Output: Red LED
Stable operation: Green LED

Timer function

ON-delay: 40 ms/OFF-delay: 40 ms/Timer OFF (switch-selectable)

Input

Control output

PNP open-collector 100 mA max. (40 VDC max.), Residual voltage: 1 V max.

Stability output

PNP open-collector 50 mA max. (40 VDC max.), Residual voltage: 1 V max.*1

Protection circuit

Reversed polarity protection, Overcurrent protection, Surge absorber

Unit expansion

Up to 16 expansion units can be connected (a total of 17 units)*2

Mutual interference suppression

FINE : 4, TURBO/SUPER: 8

Rating

Power voltage

12 to 24 VDC ±10 %, Ripple (P-P) 10 % or less*3

Current consumption

35 mA or less

Environmental resistance

Ambient light

Incandescent lamp: 10,000 lux max., Sunlight: 20,000 lux max.

Ambient temperature

-10 to +55 °C (No freezing)*4

Relative humidity

35 to 85 % RH (No condensation)

Vibration

10 to 55 Hz, Double amplitude 1.5 mm, 2 hours in each of the X, Y, and Z directions

Shock resistance

500 m/s2, 3 times in each of the X, Y, and Z directions

Case material

Polycarbonate

Weight

Approx. 40 g

*1 Only the FS-T1 and FS-M1 can provide stability outputs.
*2 If more than one unit is used together, the ambient temperature varies with the conditions below. Mount the units on the DIN rail with mounting brackets and check that the output current is 20 mA or less.
3 to 10 Units: -10 to +50°C (14 to 122°F), 11 to 16 Units: -10 to +45°C (14 to 113°F)
*3 Power to the FS-T2/T0/M2/M0 is supplied through the FS-T1/M1/V1/V11/R0, PS-T1, LV-21A/11A or CZ-V1.
*4 When extended, the ambient usage temperature varies according to the following conditions. Be sure to mount units on a DIN rail (attached to a metal plate) and ensure that the output current is 20 mA or less. When extended

For visitors who viewed this page

    Fibre Unit Finder

    • Fibre Unit Finder

    Latest / Most Downloaded

      • Trade Shows and Exhibitions
      • eNews Subscribe

      Sensors