Digital Laser SensorLV series


Amplifier Unit, Main Unit, PNP

[Discontinued model]

This model has been discontinued.

Recommended Replaceable Products
To contact us:


Select Language




PNP output

Main unit/Expansion unit

Main unit

Control output

PNP open-collector x 2 channels, 30 VDC max., 100 mA, max. residual voltage (1.0 V max.)

Response speed

FINE : 80 µs , TURBO : 500 µs , SUPER : 4 ms

Monitor output

1 to 4 V for 1 to 4 V voltage output and FINE display 0 - 3000, load resistance 20 kΩ min.

Number of interference
preventive units

FINE : No device (0) , TURBO : 2 units , SUPER : 4 units*1

Detection mode

Light intensity distinction / edge detection

Protection circuit

Reversed polarity protection, over-current protection, surge absorber

Unit expansion

Up to 7 additional expansion units can be installed (8 units including the main unit),


Power voltage

12 to 24 VDC ripple (P-P) 10% max.

Power consumption

1.5 W max. (125 mA max. for 12 V, 62.5 mA max. for 24 V)


Ambient temperature

35 to 85 % RH (No condensation)

Environmental resistance

Operating ambient humidity

-10 to +55°C (no freezing)*2


Main unit




Approx 120 g

*1 To connect several units they must be mounted on a METAL DIN rail. Ensure that the output current is 20 mA max. With several units connected, the allowable ambient temperature range varies as follows : <return , >When 2 to 5 expansion units are additionally installed : -10 to +50ºC (14 to 122ºF).<return , >When 6 or 7 expansion units are additionally installed : -10 to +45ºC (14 to 113ºF).
*2 When extended, the ambient usage temperature varies according to the following conditions. Be sure to mount units on a DIN rail (attached to a metal plate) and ensure that the output current is 20 mA or less. When extended

For visitors who viewed this page

    • For Beginners Sensor Basics Understanding fundamental - Introduction Guide to Sensors

    Latest / Most Downloaded

      • Trade Shows and Exhibitions
      • eNews Subscribe