Recent Searches
    Series ( results)
      Models ( results)
          1. Home
          2. Products
          3. Process Controls / Process Sensors
          4. Flow Sensors
          5. Clamp-on Micro Flow Sensor
          6. Models
          7. Controller DIN rail type, main unit

          Clamp-on Micro Flow SensorFD-X series

          Controller DIN rail type, main unit



          Select Language




          DIN rail type, main unit

          Display method

          Output indicator, 4-digit 7 segment display, OLED, Stability level display

          Display refresh frequency

          Instantaneous flow: approx. 5 times/second, Discharge amount/Accumulated flow approx. 30 times/second

          Response time

          50 ms/100 ms/500 ms/1 s/2.5 s/5 s/10 s/30 s/60 s (selectable, default: 500 ms)

          Integration data storage interval

          Written to the memory every 10 seconds

          Memory back up

          EEPROM (data storage period: more than 10 years, number of data rewritable times: 1 million times or more)*1

          Detection mode


          Instantaneous flow rate mode/Area mode/Pulse output (+) mode/Integrated flow mode/Shot mode (selectable)


          Instantaneous flow rate mode/Area mode/Pulse output (-) mode/Shot mode/Error output mode/Bubble alert mode/Error + bubble alert mode (selectable)



          NPN/PNP setting switch
          Open collector output: 30 V or lower, main unit: 50 mA or lower/ch.*2/expansion unit: 20 mA or lower/ch., residual voltage: 2 V or lower

          Analogue output

          4-20 mA/0-20 mA (selectable) load resistance: 500 ohms or lower

          External input

          Flow rate zero input/shot sampling input/integrated flow reset input/zero shift input (selectable) Short circuit current: NPN 1 mA or lower/PNP 2 mA or lower, input time: 20 ms or longer

          Network support

          IO-Link *3

          Protection circuit

          Power supply reverse connection protection, power surge protection, output short circuit protection, output surge protection

          Addition of expansion units

          Up to 7*4 per main unit

          Power supply

          Power voltage

          20 to 30 VDC including 10 % ripple (P-P) , Class 2

          Current consumption

          195 mA or lower (including the sensor head, excluding the load current)

          Environmental resistance

          Operating ambient temperature

          -10 to +50 °C (No freezing)

          Operating ambient humidity

          35 % to 85 %RH (No condensation)

          Vibration resistance

          10 to 55 Hz, double amplitude 1.5 mm, 2 hours each for X,Y,Z direction

          Shock resistance

          100 m/s2 (approx. 10 G) 16 ms pulse, 1000 times each for X,Y,Z direction


          Main body case/front sheet: PC, Key top: POM, Cable: PVC


          Approx. 210 g

          *1 Internal data for full time recording can be read by USB (Ver.2.0) communication.
          *2 20 mA or lower/ch when adding expansion units.
          *3 IO-Link: Specification v1.1/COM2 (38.4 kbps) is supported. If the end of the cable needs to be an M12 connector when supporting IO-Link communication, connect an M12 conversion connector (OP-88296) to the cable.
          *4 Consult the manual for the number of serially-connectable devices to the N-bus.

          Back to top

          Bedrijvenlaan 5, 2800 Mechelen, Belgium
          Phone: +32 (0) 15 281 222
          Career Opportunities: KEYENCE Career Site

          Process Controls / Process Sensors